Raxit Dock Leveller Seal for Large GAPS 20-40MM

Upgrade your loading dock equipment with the Raxit Dock Leveller Seal for large gaps, designed to effectively close side gaps between loading ramps and the ground. This high-performance seal acts as a barrier against rodents, ensuring compliance with pest-proofing standards. It is perfect for commercial and industrial facilities.

Key Features:

• Made from durable 3.2mm Santoprene with acid-resistant stainless steel wires to stop rodents from chewing through.
• Proven protection against water ingress, extreme weather, and harsh environmental conditions.
• Reduces temperature loss and prevents debris buildup
• Quick, simple installation.
• Easily tailored to fit gaps from 20mm to 40mm, effectively blocking rodent access.
• Supplied in 1000mm x 40mm strips.

• Material: 3.2mm wide Santoprene, reinforced with acid-resistant stainless steel wires.
• Dimensions: 1000mm length x 40mm width per strip.
• Gap Coverage: Seals large gaps between 20mm and 40mm. Also available for small and medium dock-leveller gaps.
• Design: Corrugated to prevent steel wire slippage.

Preparation

1. Clean the sides of the dock leveller to remove debris, dust, or old sealant.
2. Ensure the surface is smooth and ready for installation.

Installation

1. While the dock leveller is in the "down position," trim the seal at the inside edge of the dock leveller.
2. Slide the seal into position and cut it along the edge of the leveller using a Stanley knife.
3. Remove the tape backing and place the first seal on the dock leveller.
4. Position the second seal as an extension of the first seal, ensuring a snug fit.
5. Position and align the aluminium carrier with the seals, marking for cutting as needed.
6. Pre-drill holes for screws or rivets, then fasten the carrier and seal securely.
7. Gradually raise and lower the dock leveller to ensure smooth operation without friction.

Raxit Product Sheet