RodentFix Door Blocker

• Use to prevent pests from entering buildings through doors and entryways
• Using aluminium frames and lightweight, waterproof and fire resistant pvc boards
• Remove the boards from the frame when full access is required
• Also acts as a barrier for debris entering from external access points
• Available in 1m or 2m widths as standard, larger sizes available as custom order
• Kits contain 2 side channels, 1 base channel, 1 door blocker panel, countersunk self tapping screws, roll of hazard tape

Fix the 0.5m aluminium channels to the left and right walls just inside of the doorway using the provided self tapping screws. There should be at least a 35mm gap from the floor level to the start of the wall channel.

You do not need fix the base channel (1m / 2m) to the floor. You can keep this loose so that it is placed under the wall channels to accept the door blocker panel. This piece of channel will protect the panel from damage and ensure continual rodent proofing.

Measure the distance between the installed channels and cut your door blocker panel down to size.

Apply hazard tape as desired to the door blocker panel.

Slide the panels into the channels.

You can use silicone adhesive to affix the aluminium channels where screwing into substrate is not feasible. This will be less secure. Always allow for full curing before sliding in the door blocker panel

Do not install this system where the opening path of a door is blocked

Fire Certificate